filename: tfs 160k.doc version 1.2 18.04.2008 vi telefilter filter specification tfs 160k 1/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liability is assumed as a result of their use or application. n o rights under any patent accompany the sale of any such product(s) or information. measurement condition ambient temperature: 25 c input power level: 0 dbm terminating impedance: * input: 244 || -7,7 pf output: 244 || -7,7 pf characteristics remark: the reference level for the relative attenuation a rel of the tfs 160k is the minimum of the pass band at tenuation. this value is defined as the insertion l oss a e . the nominal frequency f n is fixed at 160,0 mhz without any tolerance. the v alues of relative attenuation a rel are guaranteed for the whole operating temperature range. the frequency shift of the filte r in the operating temperature range is included in the production tolerance scheme. d a t a typ. value tolerance / limit insertion loss a e 16,5 db max. 18,0 db (reference level) nominal frequency f n 160,0 mhz passband pb 44,5 mhz f n 21,0 mhz pass band ripple 1,3 db max. 2,0 db ampitude ripple in any 200khz segment within pb 0,2 db - relative attenuation a rel f n ? f n 21,0 mhz 1,3 db max. 2 db f n - 50,0 mhz ... f n - 44,0 mhz 45 db min. 40 db f n + 44,0 mhz ... f n + 50,0 mhz 43 db min. 40 db absolute group delay within pb 390 ns max. 750 ns iip3 ** 32 dbm - input power level max. 10 dbm operating temperature range otr - 10 c ... + 80 c storage temperature range - 55 c ... + 85 c temperature coefficient of frequency tc f *** - 75 ppm/k - *) the terminating impedances depend on parasites a nd q-values of matching elements and the board used , and are to be understood as reference values only. should there be additional questions do not h esitate to ask for an application note or contact o ur design team. ** ) f in1 = 156 mhz; f in2 = 158 mhz; p in =0 dbm f measurement = 160mhz ***) ? f(hz) = tc f (ppm/k) x (t-t 0 ) x f to (mhz) generated: checked / approved:
filename: tfs 160k.doc version 1.2 18.04.2008 vi telefilter filter specification tfs 160k 2/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liability is assumed as a result of their use or application. n o rights under any patent accompany the sale of any such product(s) or information. filter characteristic filter characteristic construction and pin connection (all dimensions in mm) 13,6max. 6,8max. 1 2,0max. 8 9 10 1,5 2,54 0,15 2,54 0,15 0,8 0,1 1 2 3 4 5 6 7 11 12 date code 50 ohm test circuit tfs 160k w16 1 ground 2 ground 3 ground 4 ground 5 output 6 output rf return 7 ground 8 ground 9 ground 10 ground 11 input 12 input rf return date code: year + week w 2008 x 2009 a 2010 ... 80 96 112 128 144 160 176 192 208 224 240 -70 -60 -50 -40 -30 -20 -10 0 frequency in mhz magnitude in db 140 144 148 152 156 160 164 168 172 176 180 -5 -4 -3 -2 -1 0 frequency in mhz magnitude in db 140 144 148 152 156 160 164 168 172 176 180 0.265 0.34 0.415 0.49 0.565 0.64 0.715 0.79 0.865 0.94 1.015 frequency in mhz delay in s l1 saw l2 11 5 1, 2, 3, 4, 7, 8, 9, 10 6 12
filename: tfs 160k.doc version 1.2 18.04.2008 vi telefilter filter specification tfs 160k 3/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liability is assumed as a result of their use or application. n o rights under any patent accompany the sale of any such product(s) or information. stability characteristics, reliability after the following tests the filter shall meet the whole specification: 1. shock: 500g, 1 ms, half sine wave, 3 shocks each plane; din iec 68 t2 - 27 2. vibration: 10 hz to 500 hz, 0,35 mm or 5 g respe ctively, 1 octave per min, 10 cycles per plan, 3 pl ans; din iec 68 t2 - 6 3. change of temperature: -55 c to 125c / 30 min. each / 1 0 cycles din iec 68 part 2 ? 14 test n 4. resistance to solder heat (reflow): reflow possible: three ti mes max.; for temperature conditions refer to the attached " air reflow temperature conditions" on page 4; this filter is rohs compliant (2002/95/eg, 2005/618 /eg) packing tape & reel: iec 286 ? 3, with exception of value f or n and minimum bending radius; tape type ii, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: 1700 reel of empty components at start: min. 300 mm reel of empty components at start including leader : min. 500 mm trailer: min. 300 mm g do w ct f e g d1 p2 p1 po bo ao pull off direction pin marker typ date code ko t a c n w 1 w 2 the minimum bending radius is 45 mm. tape (all dimensions in mm) w : 24,00 +0,30/-0,10 po : 4,00 0,1 do : 1,50 +0,1/-0 e : 1,75 0,10 f : 11,50 0,10 g(min) : 0,60 p2 : 2,00 0,1 p1 : 12,00 0,1 d1(min) : 1,50 ao : 7,10 0,10 bo : 13,90 0,10 ct : 21,5 0,1 reel (all dimensions in mm) a : 330 w1 : 24,4 +2/-0 w2(max) : 30,4 n(min) : 60 c : 13,0 +0,5/-0,2
filename: tfs 160k.doc version 1.2 18.04.2008 vi telefilter filter specification tfs 160k 4/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liability is assumed as a result of their use or application. n o rights under any patent accompany the sale of any such product(s) or information. air reflow temperature conditions conditions exposure average ramp-up rate (30c to 217c) less than 3c/ second > 100c between 300 and 600 seconds > 150c between 240 and 500 seconds > 217c between 30 and 150 seconds peak temperature max. 260c time within 5c of actual peak temperature between 10 and 30 seconds cool-down rate (peak to 50c) less than 6c/second time from 30c to peak temperature no greater than 300 seconds temperature / c time / s max. 260c 217c 10 ... 30 s 30 ... 150 s max. 300 s chip-mount air reflow profile
filename: tfs 160k.doc version 1.2 18.04.2008 vi telefilter filter specification tfs 160k 5/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@vectron.com vi telefilter reserves the right to make changes to the product(s) and/or information contained herein without notice. no liability is assumed as a result of their use or application. n o rights under any patent accompany the sale of any such product(s) or information. history version reason of changes name date 1.0 - generation of development specification strehl 15.11.2007 1.1 - changed data strehl 03.12.2007 1.2 - created filter specification chilla 18.04.2007 - added terminating impedances - added typical values - added temperature coefficient of frequency - added filter characteristic - added test circuit
|
